DIY GOLD CHEVRON RINGS

You need:

- Thin gold wire (mine was 0.6mm)

- Wire cutters

- Round nose jewelry plyers

1. Cut a small length of wire.



2. Fold it in half.



3. Use the plyers to press it together to create a point.



4. Carefully open the wire.



5. Fold the wire around your finger.



6. Press down the front of the ring onto the table (this is important to get the shape right) and fold the wire together at the back.



7. Cut the wire shorter, but leave enough to twist the ends together.



8. Start to twist the ends together.

9. Finish the twist with the round nose plyers.

You ring should look like this! Now make some more to stack together to create the chevron shape, and wear them on lots of fingers!