DIY Twine Pears

If you have any burnt out light bulbs at home this is a great way to upcycle  them into something new.



Start by clipping a small piece of the tree branch for the stem (I would make it about 3/4 of an inch long). Then hot glue it in the center of the small end of the light bulb.Take the end of the twine and glue it at the bottom of the stem.

Start wrapping the twine around the light bulb, I wrapped it in an upward direction one time to make sure that it fully covered the area around the stem. Make sure you add a dab of hot glue every so often to keep the twine from bunching up.Once you get to the round part of the light bulb you have to add hot glue every time you go around, otherwise it will end up bunching up and unwinding. Don’t worry if it starts to look a bit messy from the excess glue, you can pull it off and when you are done you won’t really see it.