Easy DIY Tree Topper

It is sooooo easy to make and the only tools you need are a pair of scissors and a hot glue gun!  Yah baby!

I purchased this roll of burlap garland.

Start by cutting a strand that is about 3 feet long.

Fold one end over about 2/3′s of the way over and hot glue it in place.

Follow up with the other end and secure with a dab of hot glue

Now, just do the same thing again and lay it on top of the first set of loops.

Cut another strand about 1 ft. long and fold the ends over to make it skinny 

Lay the two loops on top of the skinny strip.  Ugly side of skinny strip faces up and ugly side of loops faces up.

Add a dab of hot glue about a 1/2 inch from the bottom of the loop and squeeze the loops toward the center with your fingers.  Add more hot glue to any folds that touch.

Next, wrap the skinny strip around the bow and secure in the middle of the “pinch” with hot glue.

Now for the tails!  Cut another strip about 3 feet long and at the very center point, fold together and secure with hot glue, attach that strand to the back of the bow with hot glue.

To finish her off, fold the end of each tail in half and cut at and angle towards the bottom of the tail